Wrap Dimensions:
W: 10inch x H: 4.5 Inch
(Sizes may vary a tad bit or overlap depending on artwork design, be mindful when applying)
UV DTF wraps are easy to apply. No heat, printer or heat press required!
Step-by-step application
1. Clean the surface
Wash and thoroughly dry your cup, tumbler or mug.
Wipe with isopropyl alcohol to remove grease, fingerprints and dust.
Ensure the surface is completely dry.
2. Prepare your wrap
Carefully peel away the backing paper.
Make sure the design stays attached to the clear transfer film.
Avoid touching the adhesive side.
3. Position the design
Align the wrap carefully against your cup.
Start from one edge and gradually position it around the surface.
Check alignment before applying pressure.
4. Apply the wrap
Press the design firmly onto the surface.
Use your fingers or a soft squeegee to rub over the entire design.
Work from the centre outwards to remove air bubbles.
5. Remove the transfer film
Slowly peel the clear film away at a low angle.
If any part of the design lifts, lay the film back down and rub that section again.
6. Final check
Press down any raised edges.
Leave the design to bond for approximately 24–48 hours before washing.
Important tips
Use smooth, clean surfaces for best results.
Apply at room temperature.
Avoid stretching or pulling the wrap during application.
Avoid dishwashers, soaking and abrasive scrubbing. Hand-washing is recommended unless your transfer supplier specifically confirms otherwise.
Mugg-It pro tip:
Always test your wrap on a spare surface before applying it to a customer's finished product. A little patience during positioning saves a lot of expensive reprints!
Remember: UV DTF transfers are pressure-applied. They do not require heat or curing after application.
A great application equals a great looking product